IST – Products

Integrator

The integrator card can be plugged into any of the seven slots. Depending on the slot, the integrator is thus assigned to different terminal groups on the setpoint controller rack.

The integrator module functions as follows:

The value of a voltage applied to the input (terminals 13 to 73) is increased by means of the integration constant set on potentiometer P5 when the input signal becomes more positive and reduced by the integration constant set on potentiometer P4 when the input signal becomes more negative.

A reference voltage freely selectable on P2 is available on terminals 11 to 71. It can be set to between 0 V DC and a maximum of +12 V DC. Negative voltages are not possible. The maximum load on the voltage source is 20 mA.

A reference voltage freely selectable on P2 is available on terminals 11 to 71. It can be set to between 0 V DC and a maximum of +12 V DC. Negative voltages are not possible. The maximum load on the voltage source is 20 mA.

Detailed instructions on settings can be found in the instruction manual.

Do you have any questions about our products?